I. Translate the following English terms into Chinese.
1. headroom 2. damping pad
3. chain hoist 4. front machine bolt
5. rear machine bolt 6. guiding tube
7. spirit level 8. cross-drive screw
9. cross drive 10. changeable screw
11. torque wrench 12. locknut
13. mounting accessory 14. rail template
15. driver support 16. elevator
17. escalator 18. turnover
19. subsidiary 20. joint venture
II. Translate the following English sentences into Chinese.
1. Fix the driver support on the car rail top end.
2. Plumb the rails using the rail template.
3. A hoist can only be used to install the motor if a minimum HSK headroom distance is available.
4. Hoist the motor until the top landing floor.
5. Raise the motor using an chain hoist and place it over the driver support.
6. Once the machine rests on the machine support, it it difficult or even not possible to insert the front machine bolt on the car side owing to a conflict in space with the car rail head.
7. It is therefore necessary to insert the front machine bolt on the car side prior to putting the machine down on the machine support.
8. Insert the front machine bolt in the support bracket hole on the car side along with the damping pad and guiding tube (mounting accessories).
9. Make sure the machine is positioned over the driver support and the machine bolt holes are in line with the driver support bracket holes. Do not yet lower the machine into the driver support bracket.
10. Insert the front machine bolt on the counterweight side as well as the rear machine bolt along with the damping pad and guiding tube (mounting accessories).
11. Lower the motor using the chain hoist so that the machine comes to rest on the driver support while keeping the machine and bracket bolt holes aligned.
12. Fasten provisionally the machine to the driver support with the three machine bolts bearing in mind that some alignment work will have to follow.
13. Loosen all machine bolts sufficiently so that the machine can be aligned rightangled to the plane of the car rails.
14. Tighten the front machine bolts with torque wrench.
15. Loosen the locking nut and adjust the rear machine bolt using the integrated spirit level until the machine is level.
16. Tighten the machine bolt lock nut when the machine is level.
17. Loop the supplied locking wire through vthe machine support barcket and the front manchine bolt and twist the end of the locking wire together.
18. Screw the three supplied cross-drive screws on the wall according to the layout drawing, do not screw them all the way in.